Cart is empty
TYTAN Fire Block 113
TYTAN Fire Block 113 PRO meets or exceeds all fire block and draft stop standards. It is not an approved fire stop sealant. It is designed for the most extreme high heat and low humidity regions. It offers industry-leading 113°F ambient and can temperature without shrinking and melting in the gap. It will work the first time and not require a second application like other fire blocks. It is orange in color for easy inspection recognition. It is safe to be used around windows & doors and offers minimal shrinking. It offers industry-leading expansion to fill and seal gaps in the most extreme conditions. Applications include: electrical outlets, wire passages, ductwork, and any air passages from one building area to another. It offers premium adhesion to most construction materials including: wood, metal, masonry, glass, and most plastics. With TYTAN Fire Block 113 PRO Insulating Foam Sealant you can Build with Confidence!
ICC-ES Report ESR-3302
How to Use:
Wearing work clothes, gloves, and eye protection is recommended. 2. Use only with adequate ventilation or approved respiratory equipment. 3. Clean the surface of oil, dust and greases. Use below 59°F is not recommended. Protect the area being sprayed with tape, cloth, plastic, or other material. 4. Shake can vigorously for 30-45 seconds. Remove protective cap, invert can, and screw the can firmly onto the TYTAN dispensing gun – do not over tighten. Maintain the can in upside-down, inverted position during application of the foam. Point gun in safe direction and slowly pull trigger to test dispensing flow rate. Adjust control knob on gun handle to achieve the desired application flow. Fill cavities partially as foam will expand- do not overfill. Do not apply into spaces with inadequate moisture and humidity. 5. Spray water onto uncured foam for better results. 6. You may cut the foam after 40 minutes, cures in 24 hours (40% R.H. at 68°F). Higher humidity and temperatures will speed up curing process. Cured foam can be cut, sanded or painted. Always paint foam that is exposed to UV radiation. For more information, go to the “Try TYTAN” tab at TYTAN.comGun Cleaning: Use TYTAN Wipes to clean the tip of the gun in between uses. Only use TYTAN
Foam Cleaner in well-ventilated areas or with approved respiratory equipment. Use TYTAN Foam Cleaner’s spray nozzle to spray any uncured foam off the end of the gun applicator nozzle into a trash can or a throw away material. Remove the used foam canister from the gun applicator and spray all external uncured foam with TYTAN Foam Cleaner. Screw the TYTAN Foam Cleaner canister onto the gun and spray the cleaner through the gun to clean uncured foam out the inside of the gun barrel. Leave the TYTAN Foam Cleaner canister screwed onto the gun applicator. Tighten the control knob on the guns handle so no air can enter the barrel of the gun. Air entering the barrel of the gun for more than 2-3 minutes will decrease the efficiency and life of your gun.Foam Clean up: Spray any uncured foam with TYTAN Foam Cleaner and wipe away with TYTAN Wipes. You may also use nail polish remover, acetone, or paint thinner for easy clean-up of uncured foam. Cured foam cannot be removed with solvents. Cured foam must be removed mechanically and may leave a residue. Cured foam can be removed from skin using an industrial cleaner with pumice or petroleum jelly. Cured foam will wear away over time and is not harmful to health.
- Fire Block Technology